top of page
Wind-Master Torsion Winding Bars

Wind-Master Torsion Winding Bars

Torsion Spring Overhaul Kit (Pair of Springs)

Torsion Spring Overhaul Kit (Pair of Springs)

How to measure your garage door spring(s)
How to replace your spring(s)
$14.99 Value/ FREE pair of cables with every spring order! Enter code at checkout.
7ft high Door --- Enter cables7
8ft high Door --- Enter cables8
Visit Homepage To
See ALL Spring Options
Pair of Garage Door Springs w/ Winding Bars
Price shown after entering measurements is for Pair of Springs (LEFT AND RIGHT SPRING INCLUDED) for torsion systems set above the garage door. If there are multiple springs on your garage door we strongly recommend replacing BOTH torsion springs. We offer a vast selection of wire and spring sizes and both left and right wind torsion springs.                Spring Length Over 40 Inches? Call Us!
 
Want a High Cycle Upgrade to your Springs? Don't get ripped off, Call us! We'll Engineer your High Cycle Springs over the phone for up to 80% less than our competitors!  260-691-3822
Need Just One Spring? Click Here!
 

Pair of Garage Door Springs w/ Winding Bars

$59.99Price

  • Torsion spring coated and oil tempered and include cones installed. Springs are factory coated black for smoother, cleaner operation. For use on garage doors with standard lift drums. Minimum 10,000 cycles, Springs are made of steel coils with aluminum cones installed!

*See Reviews
Wire Chart
Garage door parts
[Wire Chart]
Click Here
We Ship our springs with UPS

Super Fast Shipping on all Spring Orders.

online garage door parts
How to
wire chart
Check out ALL of our How-to Videos HERE!
Garage Door Parts Diagram

    WARNING: Torsion springs, extension springs, and other garage door hardware can cause serious injury or death if not handled and installed properly.

 

    Professional installation is recommended. Do NOT attempt to install springs or hardware yourself unless you have the proper tools, reasonable mechanical aptitude and experience, and upper arm strength. Read and understand all instructions before you begin work.

 

    Extension and torsion springs, along with attached hardware, are under extreme tension at all times. All tension must be released from springs before any work is performed.

How to Measure your Torsion Spring

This method of measuring your torsion spring requires you to measure the existing springs.  Use this method if the door worked correctly before the spring(s) broke and the garage door has not been tampered with.  To measure the torsion springs, follow each of the following steps carefully.  If the garage door has two springs measure each spring individually.  It is not uncommon to have two different size springs.  If you prefer a matching set, we can convert a mismatched set to a matching set. You can also always call us at (855) 566-0959.

Step 1 Determine Springs ID (Inside Diameter)

For your broken spring(s) measure the inside diameter of the spring. If the spring is in one piece you can normally find the ID on the cones, P175 for 1 3/4" and P200 for 2". Typically residential springs will have a 1 3/4" or 2" inside diameter.

Step 2 Determine Spring Wind

Most standard residential torsion systems have two torsion springs, one on the  right and left. The Left spring is right hand wound(RHW), and the right spring is left hand wound(LHW). If one spring is broken on your torsion system, we highly recommend replacing both springs.

Torsion Springs