© 2019 Express Door. All Rights Reserved

  • Facebook
  • YouTube

Contact Us

Express Door

366 E 600 N Columbia City, IN 46725

Tel: 260-691-3822

Wholesalegdparts@gmail.com

home button.png

Garage Door Springs

Scroll Down for How to Measure Your Spring!
How to measure your garage door spring(s)
How many turns to put on your spring(s)
Tech's wife demonstrates winding spring
$14.99 Value/ FREE pair of cables with every spring order! Enter code at checkout.
7ft Door --- Enter cables7
8ft Door --- Enter cables8

Wind-Master Torsion Winding Bars

$14.95Price
How to replace your Spring(s)
How to weigh your garage door
Website Walk Through / Ordering Process
Spring turns chart
*On each spring
 Not sure what spring you need? We make it easy.
Take a picture of the garage door itself from inside your garage, and we'll tell you what spring(s) you need.

*Please note a picture of the Garage Door itself is needed, not just the springs above the door*

Email pictures to Wholesalegdparts@gmail.com

*Best

We Ship Via UPS
 
 

WARNING: Torsion springs, extension springs, and other garage door hardware can cause serious injury or death if not handled and installed properly. Professional installation is recommended.

Do NOT attempt to install springs or hardware yourself unless you have the proper tools, reasonable mechanical aptitude and experience, and upper arm strength. Read and understand all instructions before you begin work.

Extension and torsion springs, along with attached hardware, are under extreme tension at all times. All tension must be released from springs before any work is performed.

 
How to Measure your Torsion Spring

This method of measuring your torsion spring requires you to measure the existing springs.  Use this method if the door worked correctly before the spring(s) broke and the garage door has not been tampered with.  To measure the torsion springs, follow each of the following steps carefully.  If the garage door has two springs measure each spring individually.  It is not uncommon to have two different size springs.  If you prefer a matching set, we can convert a mismatched set to a matching set. You can also always call us at 260-691-3822.

Step 1 Determine Springs ID (Inside Diameter)

For your broken spring(s) measure the inside diameter of the spring. If the spring is in one piece you can find the diameter on the cones, p175=1 3/4" and p200=2". Typically residential springs will have a 1 3/4" or 2" inside diameter.

Step 2 Determine Spring Wind

Most standard residential torsion systems have two torsion springs, one on the  right and left. The Left spring is right hand wound(RHW), and the right spring is left hand wound(LHW). If one spring is broken on your torsion system, we highly recommend replacing both springs.

Right Wound
Left Wound
Center Mount
Red Winding Cone
Black Winding Cone
Left Wound
Right Wound
(Red Winding Cone)
(Black Winding Cone)
Step 3 Determine Wire Size

The most efficient way to measure the wire size is to measure 10 coils and then measure 20 coils and compare the measurements to the chart below.  Measure to the nearest 1/16" of an inch.  It is important to make sure there are no gaps between the coils.  Measuring coils that have gaps will give incorrect measurements.

Step 4 Determine Spring Length

When measuring your torsion spring, remember that in order to get a proper measurement the spring must be un-wound. If the  spring is in two parts, unscrew set screws and connect spring ends together to  get a total measurement. Do not include the cones in the measurement.

Check out our How-To Videos!
Or Visit our Frequently Asked Questions Page
Check out our How-To Videos or scroll down for how to measure your springs!